BeltStation Firmware


Please follow the steps below for upgrading the BeltStation Firmware:


1. Download the firmware for either the 4-channel or 2-channel system

    For 4-Channel System: 
Download "4CH_Belt_TMR425_03_10_00.zip" here

    For 2-Channel System:  Download "2CH_Belt_TMR225_03_10_00.zip" here

    For MasterBelt System:  Download "MasterBelt_TMR2MS_03_10_00.zip" here

   
 
  2. Prepare the BeltStation for updating
 
  • With the BeltStation power OFF, press and hold the "CALL" button and power the BeltStation ON
  • The BeltStation LCD should indicate that it is ready for a "New Image"
  • Connect the USB cable from your PC to the Mini USB connector on the side of the BeltStation located under the rubber flap
  3. Locate the target device
 
  • Click the "Locate Device" button in Code Updater
  • The banner of Code Updater should indicate what target you are attempting to program - In this case it should say "belt"
  4. Point Code Loader to the Firmware (.hex) file
 
  • Click the "Browse" button and locate the Firmware (.hex) file that you located in step 1 above
  5. Upgrade the BeltStation
 
  • Click the "Upgrade" button
  • The target will self program and boot

Note: It may be necessary to pair
BeltStations to BaseStations again after upgrading the Firmware.