Settings for Program/Audio in

Program/audio in can be disabled on a HelixNet Remote station if you wish to conserve system resources on a large system. When disabled, program/audio will not be available to the remote station.

To configure the audio settings for the program/audio in:

  1. In Menu mode, select Audio Settings and then PGM/Audio In.

  2. To disable/enable program audio:
    1. From the third menu, select Mode.
    2. From the fourth menu, scroll to Disabled and select it by pushing the rotary controller
    3. To re-enable program/audio, scroll to Enabled and select it by pushing the rotary controller.

  3. To edit the label for this input:

    1. From the third menu, select Label.

    2. From the fourth menu, select the existing label by scrolling to it and pushing the rotary controller. Edit the label by rotating the controller to scroll through letters and digits and pushing to select a letter/digit.

    3. When you have done, scroll to Save and push the rotary controller. To exit without saving changes, go back to the third screen.

  1. To select the gain:

    1. From the third menu, select Gain.

    2. From the fourth menu, select one of the following:

    • + 12dB

    • +  6dB

    •     0dB (default)

    •   - 6dB

    • - 12dB

    1. To confirm the selected setting, press the rotary control.

  1. To select the IFB dim level:

    1. From the third menu, select IFB Dim Level.

Note: The IFB Dim Level determines the volume level the Program Level is reduced to when it is interrupted by the IFB.

  1. From the fourth menu, select one of the following:

  • IFB Disabled (default)

  • -  6dB

  • -12dB

  • -18dB

  • -24dB

  • Full Cut

  1. To confirm the selected setting, press the rotary control.

  1. The action trigger activates a relay when receiving audio in above the VOX level on a Partyline Channel. You can enable or disable the action trigger.

    1. In Menu mode, select Audio Settings and then Program Input.

    2. From the third menu, select Action Trigger.

    3. From the fourth menu, select one of the following:

    • Enabled (default)

    • Disabled

    1. To confirm the selected setting, press the rotary control.

Note: You can also configure the action trigger using Menu Mode > Modules Settings.

  1. To select the VOX:

    1. From the third menu, select VOX.

    2. From the fourth menu, select one of the following:

    • Enabled

    • Disabled (default)

    1. To confirm the selected setting, press the rotary control.

  1. To select the VOX Off Delay:

    1. From the third menu, select VOX Off Delay.

    2. From the fourth menus, select one of the following:

    • .5 sec (default)

    • 1 sec

    • 2 sec

    • 3 sec

    • 4 sec

    1. To confirm the selected setting, press the rotary control.