Connecting to 4-wire equipment

To minimize noise, use screened (shielded) cable when connecting 4-wire ports.

Pin-out configuration

Pin-out configuration can be set on LQ Series 4-wire interfaces (not 4W + GPIO). This is a software switch that switches the configuration of the pins on the RJ45 etherCON connectors, according to the device you are connecting to. See Interconnection Guidelines.

Pin-out configuration is set ‘to Matrix’ by default. To set the pin configuration of a device:

1. Access the CCM for any unit in the Link-Group.

2. Navigate to Device > Ports .

3. Select either ‘to Matrix’ or ‘to Panel’.

Click image to enlarge/minimize