Using rotary panel keys

By default, the talk label is displayed on a key, unless a listen only label is configured for the key.

For all panel types in assignment panel mode, the talk labels are shown on possible IFB destinations and the listen labels are shown when the user is selecting an IFB source.

The rotary control and talk button normally default to latching unless the non-latching option is configured in EHX under Global Settings (Latch Disable set to True) for the destination port.

In the default state (latching), pressing the rotary control or talk button momentarily latches the key.

If you hold the rotary control or talk button for more than 200ms, the key does not latch and the connection terminates as soon as the key is released.

When the rotary control is inactive, the center of the control is lit dim green. When the talk button is inactive, the button is lit dim red.

If the brightness control is turned down further, the dimmed lighting of the rotary control and talk button is turned off entirely.

When you press the rotary control to establish a listen route, the center of the control is lit bright green. When you press a talk button to establish a talk route, the button is lit bright red.

To cancel the connection press the rotary control or talk button.

An incoming call is signaled by a flashing red Reply key talk button. To pick up the call press the reply key talk button.