Setting a static IP address

The V-Series Iris panel uses two IP addresses when connected over AoIP. There is an Admin address and an Audio (AES67) address. When the panel is connected in IVC mode, only the Admin IP address is used. From the front panel menus, you can set either of these IP addresses as static.

To set a static IP address for Audio (AES67):

  1. Press the Menu button, and navigate to IP Setup > Net Setup > AES67 DHCP > AES67 > Disable > AES67 IP
  2. Enter the required static address.

To set a static IP address for Admin:

  1. Press the Menu button, and navigate to IP Setup > Net Setup > DHCP > DHCP > Disable > DHCP
  2. Enter the required static address.

    Note: The Panel’s IP ADDRESS and AES67 IP must be set on the same subnet. For example: IP Address = 192.168.12.34; AES67 IP = 192.168.12.35.