LAN Configuration Rules

Note:Do not plug any two LAN ports into the same LAN or VLAN. This can create a network loop affecting IP stability.
Note:Configuring/changing the AES67 IP address will cause the Base Station to reboot.

AES67 Rules

  • AES67 should not be on the same subnet as Management unless on the same LAN port

  • AES67 cannot be on the same LAN port as DANTE primary or secondary

Note:Clear-Com recommends that you configure AES67 port on the Station to a Static IP address if there is no third-party DHCP server on the network.

IP Rules

  • The IP addresses cannot be in the reserved range: 10.0.0.0-10.0.0.7

    • The subnet mask may cause an overlap with the reserved range

  • The IP addresses cannot be in the LQ tunnel range 172.23.xxx.xxx

  • The IP addresses cannot be in the localhost range 127.xxx.xxx.xxx

  • The IP addresses cannot be in the multicast range 224.xxx.xxx.xxx-239.xxx.xxx.xxx

Static IP Rules

  • The static IP addresses cannot be in link local range: 169.254.xxx.xxx

Note:Clear-Com recommends that you configure AES67 port on the Station to a Static IP address if there is no third-party DHCP server on the network.

Dante Rules

  • Dante primary and secondary cannot be on the same LAN port (rear connector)

Management Rules

  • You cannot disable the Management LAN.