Connecting a splitter with a fiber connection
You may wish to connect a E-IPA Matrix Card to a splitter (FSII-SPL) using Fiber. In this case, you need to install Fiber modules in the E-IPA Matrix Card and the splitter.
- Modules are available for single mode Fiber cable (SFP-SMFO-100M-LX or HLI-SMFO) and multi-mode Fiber cable (SFP-MMFO-100M-FX or HLI-MMFO)
- Two SFP modules are required, one for the E-IPA Matrix Card and one for the splitter.
- Modules can be hot patched, no need to power off devices.
Install splitter Fiber module. 
Once the modules are installed, the Base Station and the splitter can be cabled with the correct Fiber cable (single mode or multi-mode depending on existing cabling). You will see the Base Connection indicator on the front of the splitter change from RJ45 to Fiber.
You must also set the transceiver port to Fiber in the Core Configuration Manager. Navigate to Device>Station>Transceiver ports.
Install Fiber modules