Updating the Software

Software can be updated from a Main Station or locally in the USB connector on the front of a Remote Station. Updating from the Main Station is recommended when possible.

To update the software:

  1. After downloading the software update, copy the update to a USB memory stick.

  1. Insert the memory stick into the USB connector.

  2. In Menu mode, select Administration and then Software.

  3. From the third menu, select Update.

  4. The fourth menu displays the new software version information on the USB memory stick. To start updating to the new software, press the rotary control.

The process of updating the software takes several minutes. The following system messages are displayed during the process:

Loading image

Erasing flash

Writing to flash

Verifying flash

Successful

WarningTriangle.JPG

Do not turn off the power to the Remote Station during the software (firmware) update. Turning off the power can damage the device.

Notes: Do not remove the USB memory stick from the Main Station or Remote Station until the software update is completed.
  The Remote Station resets automatically. You are not required to restart the Remote Station. To check that the software upgrade was performed successfully, see Viewing the current versions of the software.